MPL - Adapter for iPPE Workbench
The following messages are stored in message class MPL: Adapter for iPPE Workbench.
It is part of development package AD_MPL in software component PM-EQM-CC. This development package consists of objects that can be grouped under "Master Parts List".
It is part of development package AD_MPL in software component PM-EQM-CC. This development package consists of objects that can be grouped under "Master Parts List".
Message Nr ▲ | Message Text |
|---|---|
| 000 | ** Customizing ** |
| 001 | The characteristic &1 has wrong properties |
| 002 | Characteristic &1 does not belong to the class &2 |
| 003 | No filter/focus matching the selection was found |
| 004 | Choose a filter/focus |
| 005 | Selection criteria were changed. Selection is from the old results. |
| 006 | Parameters for function module &1 are incomplete |
| 010 | ** General Checks ** |
| 011 | Cancel-part check not possible because of missing Customizing settings |
| 012 | &1 &2 / part &3: Document &4 is missing in work scope |
| 013 | &1 &2: Part &3 not valid according to variant configuration or ECM |
| 014 | &1 &2: Part &3 is not valid according to work scope |
| 015 | &1 &2 is not assigned to class &3 class type &4 |
| 016 | &1: Missing value for characteristic &2 in class &3 class type &4 |
| 017 | &1 &2: CANCEL-Part characteristic missing in class &3 class type &4 |
| 018 | &1 &2: Part &3 is not a CANCEL part for &4 |
| 019 | &1 &2 does not contain a part number |
| 020 | Part &1 is a fully interchangeable part |
| 021 | No checks are run because of missing Customizing settings |
| 022 | The current part &1 is not possible at this location |
| 023 | &1 &2: The current part &3 is not intended as a cancel part for &4 |
| 024 | &1 &2: Neither the current part nor the cancel part are not specified |
| 025 | &1 &2 &3 &4 |
| 026 | Various configurations found for function identifier &1 |
| 050 | ** Checks on Set relations ** |
| 051 | Part &1 is related to &2 &3 with unknown dependencies |
| 052 | Set &1 &2: No information is available for installed parts for &3 &4 |
| 053 | Combination of part &1 in &2 and &3 in &4 is not allowed |
| 070 | ** Messages for the iPPE test application ** |
| 071 | BADI implementation 'MPL_TEST' is not active |
| 072 | Messages: Test application for the interface to the iPPE workbench |
| 080 | Class & successfully created |
| 081 | Characteristic & successfully created |
| 090 | Error reading data from database (node check for archiving: &1) |
| 091 | Active link to equipment for node &1 |
| 099 | Part &1 is a freely-defined interchangeable material |
| 100 | Install EA-IPPE 404 or higher before activating the BF |
| 899 | Customizing for released characteristic status (table TCMS) missing |