QETB - QM Toolbox
The following messages are stored in message class QETB: QM Toolbox.
It is part of development package QETB in software component QM-IM. This development package consists of objects that can be grouped under "Toolbox: Results recording".
It is part of development package QETB in software component QM-IM. This development package consists of objects that can be grouped under "Toolbox: Results recording".
Message Nr ▲ | Message Text |
|---|---|
| 001 | & is not a valid number |
| 002 | & is not a valid code for this characteristic |
| 003 | & is not a valid entry (only A or R accepted) |
| 004 | Log contains & error, & warning and & info messages |
| 005 | Toolbox was called without data |
| 006 | Data was copied to the toolbox without an inspection lot number |
| 007 | Data was copied to the toolbox without an operation number |
| 008 | No control chart is run for this characteristic |
| 009 | No log is available |
| 010 | Wait until the save operation currently running has finished. |
| 011 | System error occurred during the locking procedure |
| 012 | No data available |
| 013 | Position the cursor on a results field |
| 014 | Cursor is incorrectly positioned (inspection point identification) |
| 015 | & is not a valid date |
| 016 | & is not a valid time |
| 017 | Save first |
| 018 | Wait until the save operation has finished |
| 019 | No authorization |
| 020 | Scrolling is not possible |
| 021 | Save operation is running. Try function again later. |
| 022 | You can only make STI evaluations for characs. with measured values |
| 023 | Single values are required for STI evaluations |
| 024 | You cannot record characteristic results for inspection lot & |
| 025 | You cannot process this charac. with this transaction. |
| 026 | There is no single result available |
| 027 | There are no characteristics available with long-term inspections |
| 028 | The field & must have an entry for the inspection point |
| 029 | You must enter a partial lot for the inspection point |
| 030 | You must enter a valuation for the inspection point |
| 031 | You must enter a quantity for the inspection point |
| 032 | You must enter a batch for the inspection point |
| 033 | The characteristic is currently locked |
| 034 | You cannot use this function in the entry line for new inspection points |
| 035 | This Is Not a Long-Term Characteristic |