SCM_MD_R3_PI - SCM Master Data in Plug-In
The following messages are stored in message class SCM_MD_R3_PI: SCM Master Data in Plug-In.
It is part of development package R3_SCM_MD in software component CA. This development package consists of objects that can be grouped under "SCM Master Data Plug-In".
It is part of development package R3_SCM_MD in software component CA. This development package consists of objects that can be grouped under "SCM Master Data Plug-In".
Message Nr ▲ | Message Text |
|---|---|
| 001 | The warehouse number of the decentralized SCM system must be unique |
| 010 | Unit &2 is not a valid unit of measure for the material |
| 011 | Unit &1 does not correspond to base unit of measure of material |
| 020 | Change in parallel unit of measure no (longer) possible |
| 021 | Alternative unit of measure (&1) cannot be valuation unit of measure |
| 022 | Alternative unit of meas. &1 must be defined as parallel UoM alternative |
| 023 | First reset the category of parallel unit of measure &1 |
| 024 | You can only define one parallel unit of measure |
| 025 | Parallel unit of measure cannot be the base unit of measure |
| 026 | Alternative UoM &1 must not be defined as parallel UoM alternative |
| 027 | First define a parallel unit of measure |
| 028 | Parallel unit of measure &1 has same dimension as unit of measure &2 |
| 029 | Alternative unit of meas. &1 must be defined as parallel UoM alternative |
| 030 | Unknown parallel-unit-of-measure category (&1) for unit of measure &2 |
| 031 | Category of PUoM for &1 must correspond to cat. of other UoM of same dim. |
| 032 | Category of parallel UoM '&1' not supported by SAP standard |
| 050 | You can only active IUID for serial number requirement 'C' |
| 051 | You can set UII type only if the IUID is active |